GEOMATE Corp. announces tolerance analysis extension to Autodesk Inventor

San Jose, CA. February 27, 2002 - GEOMATE Corporation today announced GrafiCalc 3. 0 next generation analysis software plug-in for Autodesk Inventor. GrafiCalc 3. 0 delivers hard facts regarding tolerance, fit, and manufacturability to Autodesk Inventor users in early design stages - while conflicts are easier to detect and less expensive to fix.

Until today, Autodesk Inventor users faced following hard choices for verifying tolerance and fit between parts and assemblies:

Do nothing about it and hope for the best.

Submit finished design for expert analysis and go through costly redesign.

Make physical models to check tolerances and go through costly redesign.

Using GrafiCalc 3.0 seamless extension, Autodesk Inventor users can automatically extract geometry to define flexible tolerance models and perform:

Min-Max Stackup

Worst Case analysis

Sensitivity analysis of individual contributors

Tolerance budgeting

Fit and clearance analysis

Additionally, GrafiCalc incorporates groundbreaking technology that enables Autodesk Inventor users to "backsolve" geometry to meet optimal position and fit goals, automatically.

Price: $995

Availability: Immediate

www.graficalc.com

 

Sponsored Links

AnyDWG Offers DWG to PDF, DWG to DXF, PDF to DWG, DWG to JPG, PDF to DXF Converters

AutoDWG offers DWF to DWG, DWG to PDF , PDF to DWG, DWG to Flash Converters, DWG Viewer.

eCampus.com Get your stuff for College... Cheap! Textbooks, Greek Gear, DVD's, University Clothing, Computers and MORE!

Access Your PC from Anywhere Free Trial plus 10% Off!